Find solutions to common issues and download the complete GUI documentation for your Marina Trash Skimmer.
The pump is drawing too much power. This could indicate a blockage or cable issue.
Solution: Check for blockages (twine, bags, wood) in the propeller. Inspect the cable for shorts. Verify the propeller spins freely when power is applied.
The pump is drawing too little power, possibly due to an open circuit or the pump not being submerged.
Solution: Ensure the pump is connected securely to the control panel. Check for propeller blockages. Confirm the pump is fully submerged in water.
The power supply voltage is below the set threshold, indicating a potential power supply failure.
Solution: Power cycle the control panel by turning it off and on. If the error persists, contact KECO support.
Internal temperature of the control panel has reached a critical limit (70°C / 158°F).
Solution: The system will automatically stop and resume once temperature drops below 60°C (140°F). Ensure adequate ventilation around the control panel.
The SD card is not detected or has become corrupted.
Solution: Remove and reinsert the SD card. If the error persists, replace with a new SD card formatted to FAT32.
Download the complete Trash Skimmer GUI Documentation (Revision 11) for detailed instructions on all screens, settings, service procedures, and troubleshooting.
32-page PDF • Last updated: May 2024
Download PDF ManualOur team is ready to assist you with any questions or service needs